6 Facts About Garbage Everyone Thinks Are True

How to Replace a Garbage Disposal.

At times, even the best care and maintenance can prevent a garbage disposal from breaking down. However, with proper tools, installing a new one is going to be simple and stress-free. The question however is, how exactly do you really know when to replace your garbage disposal? Well, when you flip the switch to turn on the garbage disposal and all you get is a loud, metal on metal grinding noise, then you should know that something is amiss. The good news is that replacing a garbage disposal does not require you to have a degree from a well-known university in Rocket Science. Even in the event that you have not done much plumbing, you will have the ability to manage it as it’s a trouble-free procedure that any patient person could successfully manage. This guide is majorly going to talk about how you need to replace your garbage disposal without the assistance of a specialist.

The very first thing you need to do would be to get ready for the job ahead of you. It is prudent that you have all the parts listed on the instruction sheet to avoid destructions once you begin the project. What follows must be turning off the ability to the disposal in the circuit -breaker box. One of the most important things you should not neglect to do is to confirm the amperage off the circuit in order to be certain the disposal will not overload it. Once all that is done, you should disconnect the drain arm from the disposal unit with the use of pliers so as to loosen the spring clamp holding the dishwasher drain tube in place. After that, you should get rid of the drain tube in the unit and proceed to the next step.

Secondly, you should consider taking the disposal device. The best way to do this is by twisting it from the mounting nut since you dump out any residual debris and water. What’s that you should turn the device upside down with the sole purpose of removing the plate covering the electric connections. Once that is finished, you should remove the grounding cable and screw nuts in order to pull the cable out of the device. You should take note that if your disposal will be the same as the old unit, there’ll be no need to replace the mounting hardware. If that is not the case, you will have to remove the existing mounting assembly in order to drain.

This step should be to set up the hardware whereby you will need to place a rubber seal on the bottom of the drain flange. You will then have to join the mounting ring with threes screws and tighten it until the assembly is even and tight. Last, you’ll have to prepare the new disposal so you finish the installation.

5 Key Takeaways on the Road to Dominating Equipment

Why not learn more about Disposals?

Categories: Technology